Uvod
This manual provides comprehensive instructions for the installation, operation, and maintenance of the Hunter 99179 Original Ceiling Fan Remote Control and Canopy Kit. This kit is specifically designed to enhance the functionality of Hunter "Original" series ceiling fans by adding remote control capabilities for fan speeds and lighting.
The kit includes a remote control unit and a canopy designed to house the receiver. It integrates with your existing two-wire fan setup, offering convenient control over three fan speeds and the fan's light fixture.
Važne sigurnosne informacije
- Električna sigurnost: Always disconnect power at the circuit breaker or fuse box before attempting any installation, maintenance, or repair. Failure to do so can result in serious injury or death.
- Kompatibilnost: This kit is designed for use SAMO with Hunter "Original" series ceiling fans. It is not compatible with other fan models or brands.
- Downrod Requirement: Installation requires a downrod of 12 inches or longer (sold separately). The receiver unit is designed to fit within the canopy, which necessitates sufficient space provided by a longer downrod.
- Profesionalna instalacija: If you are unfamiliar with electrical wiring or ceiling fan installation, it is recommended to consult a qualified electrician.
- Lokalni kodovi: Ensure all installation procedures comply with local electrical codes and ordinances.
- Integritet proizvoda: Ne modificirajte proizvod niti ga koristite u druge svrhe osim za one za koje je namijenjen.
Sadržaj paketa
Prije početka instalacije provjerite jesu li sve komponente prisutne:
- Jedinica za daljinsko upravljanje
- Daljinski prijemnik
- Canopy (for receiver housing)
- Mounting Hardware (screws, wire nuts, etc. - specific items may vary)
Image: A Hunter ceiling fan, representative of the type of fan compatible with the 99179 remote and canopy kit.
Postavljanje i instalacija
Follow these steps carefully to install your Hunter 99179 Remote Control and Canopy Kit:
- Prekid napajanja: Before starting, turn off the electrical power to your ceiling fan at the main circuit breaker or fuse box.
- Pristupno ožičenje: Carefully lower the existing canopy from your Hunter Original ceiling fan to expose the wiring connections.
- Remove Old Receiver (if applicable): If an old receiver is present, disconnect its wiring and remove it.
- Install New Receiver: Connect the new remote receiver's wires to the corresponding fan and household wires. Ensure all connections are secure using wire nuts. The receiver is designed to fit within the new canopy.
- Pozicija nadstrešnice: Carefully tuck the wired receiver into the new canopy. Ensure no wires are pinched.
- Sigurna nadstrešnica: Mount the new canopy securely to the fan's mounting bracket. Confirm that the downrod is at least 12 inches long to accommodate the receiver within the canopy.
- Vrati snagu: Once installation is complete and all connections are secure, restore power to the ceiling fan at the circuit breaker.
- Uparivanje daljinskog upravljača: Follow the instructions provided with the remote control unit to pair it with the newly installed receiver. This typically involves pressing a button on the remote within a short time after restoring power.
Bilješka: The new canopy is designed to accommodate the receiver. Some older Hunter Original fan mounting plates or downrods may not be compatible with the new canopy's dimensions. Verify fit before final installation.
Upute za rad
Your Hunter 99179 remote control provides convenient operation of your ceiling fan and light:
- Kontrola brzine ventilatora: Use the designated buttons on the remote to cycle through three fan speeds (Low, Medium, High) or to turn the fan off.
- Kontrola svjetla: Use the light button to turn the fan light on or off. Some remotes may also support dimming functions if your fan and light kit are compatible.
- Zamjena baterije: If the remote control stops responding, replace the batteries. Refer to the remote's specific instructions for battery type and replacement procedure.
Održavanje
To ensure optimal performance and longevity of your Hunter 99179 kit:
- Čišćenje: Periodically wipe the remote control and canopy with a soft, dry cloth. Do not use abrasive cleaners or solvents.
- Provjera baterije: Replace remote control batteries as needed to maintain reliable operation.
- Pregled ožičenja: Annually, or if issues arise, ensure all electrical connections within the canopy are secure and free from corrosion. Always disconnect power before inspection.
Rješavanje problema
If you encounter issues with your remote control and canopy kit, refer to the following common solutions:
| Problem | Mogući uzrok | Otopina |
|---|---|---|
| Remote not responding / Fan or light not working |
|
|
| Canopy does not fit / Receiver cannot be housed |
|
|
| Smetnje od drugih uređaja |
|
|
Tehnički podaci
- Broj modela: 99179
- Proizvođač: Hunter Fan Company
- Dimenzije proizvoda: Otprilike 6 x 6 x 7 inča
- Težina artikla: Otprilike 2.35 funti
- Voltage: 120 volti
- Izvor napajanja: Na kabel-električni
- Materijal: Metal
- Certifikacija: ETL naveden
- Upotreba: Ceiling fan remote control and canopy accessory
- Posebna značajka: Heavy Duty construction
- Kompatibilni uređaji: Hunter "Original" series ceiling fans
Informacije o jamstvu
No specific warranty description is provided for the Hunter 99179 Remote Control and Canopy Kit in the product details. For warranty inquiries, please contact Hunter Fan Company directly or refer to the documentation included with your original Hunter "Original" ceiling fan.
Korisnička podrška
For further assistance, technical support, or to inquire about parts, please visit the official Hunter Fan Company webstranici ili se obratite njihovom odjelu korisničke službe.
Hunter Fan Company Webstranica: Visit the Hunter Store on Amazon
